15 models for excavators with operating weight from 8 to 200 ton

1. Tubes with swivels fully protected from any bad uses and resistant to vibrations in case of lack of nitrogen in the chamber.
2. Regulation of the operating pressure For the FX series (FX950-15000), it is possible to adjust the working pressure by a manual valve located frontally, on the distribution of the breaker.
3. Anti-dust and underwater work set up You can prevent the entry of dust and water into the breaker by blowing air into the proper hole in the front part of the breaker, with a pressure not less than 10 bar.
4. Automatic hydraulic greasing device (optional, mounted on the breaker) The Beka-Lube automatic lubrication system optimizes the lubrication procedure and reduces maintenance and downtimes.
5. Automatic hydraulic greasing device with exclusive Hammer electric control (optional, mounted on the excavator). Innovative electric system with automatic grease distribution, less liable to vibration breakages thanks to its own tank of grease with a capacity of 4 kg or 8 kg, making thus the system cheaper than all the other devices with single cartridges.
6. Manual adjustment of blows For the FX series (FX950-FX15000), the regulation of the blows is carried out manually by an adjusting valve located on the side of the breaker.
7. Hydraulic system for blank firing the hydraulic system is a regenerative circuit of oil that avoids blank firings when the tool is not in contact with the rock.
8. The piston is built with a special geometry such as to keep a constant energy of impact, as well as for reducing breakages in conditions of criticality.
9. Anti-dust system for tunnels (optional) The anti-dust system consists of the addition of a dustproof seal mounted in the lower bush so to avoid the entering of impurities in the circuit.